Published 7:11 am Monday, December 15, 2008
Safety tips to prevent holiday fires
While holiday decorating is all about adding fun, sparkle and warmth to a very special season, it’s important to remember that many of our favorite decorations carry the risk of fire or electrical injury if not used carefully. Don’t let a preventable accident take the enjoyment out of your holidays - whether you’re excitedly preparing for Christmas, Hanukkah, or Kwanzaa, take a few minutes to consider these decorating safety tips offered by the experts at CableOrganizer.com – a leading provider of cable, wire and equipment management solutions.
Lights and Decorations
When shopping for lights, electric decorations and extension cords, purchase only the ones that are UL-listed
If you’re planning to decorate outdoors, make sure that you use lights and decorations that are rated for outdoor use. Putting indoor-only products outside in the weather can result in electric shock and fire hazards.
If you’re in doubt as to whether light strings are rated for indoor or outdoor use, just check the color-coded UL mark on the product’s package. A green holographic UL mark says, “indoors only, please,” while a red one indicates that the product is safe for both indoor and outdoor use.
Whether they’re brand-new out of the box or seasoned veterans from holidays past, before you put them up, inspect all lights, electric decorations and extension cords for signs of damage to wire insulation, plugs, and bulbs. If the damage can be repaired (i.e. broken bulbs replaced), do not use the item until the repair has been made. If cords and plugs are damaged, discard and replace the decoration.
Always unplug lights before changing bulbs, replacing fuses, or making any other repairs.
If you need to replace a bulb in a string of Christmas lights, make sure that the wattage rating of the replacement bulb you’re using matches that of the light strand. Using a bulb with too high a wattage can cause the light string to overheat, creating a fire risk.
When hanging Christmas lights outdoors, reduce your risk of electric shock by passing up metal ladders in favor of ladders made of non-conductive materials like wood or fiberglass-reinforced plastic.
Only use lights and decorations in accordance with manufacturers’ instructions.
Before you begin decorating, verify how many strands of lights it is safe to connect end-to-end (as a general rule, it’s 3).
Be careful not to overload extension cords. Before you start plugging in, find out the wattage rating of your extension cord, as well as the power requirements of any lights or decorations you’re planning to plug into it. A wattage rating is the amount of electricity that an extension cord is built to carry, and if the combined power requirements (or “pull”) of your lights and decorations exceed that rating, overheating and fire can occur.
Every so often, check Christmas light wires to make sure that they’re not warm to the touch.
Always turn off all Christmas lights and decorations before going to bed or leaving the house.
Setting Up Your Christmas Tree
The way you set up and care for your tree has a big effect on how long it will last, how beautiful it will stay, and, ultimately, how safe it will be to have in your home.
Before putting your new Christmas tree into its stand, cut a couple of inches off the bottom of the trunk to expose fresher (and far more absorbent) wood. Taking a few minutes to do this will improve your tree’s water intake, and make it harder for your tree to catch fire.
Your tree stand should have a capacity of at least one gallon, which is the amount of water that the average 6-foot Christmas tree can consume in a day’s time. As a general rule of thumb, live Christmas trees require one quart of water for every inch of trunk diameter.
Water live Christmas trees daily.
Position tree a minimum of 3 feet away from candles, fireplaces, space heaters, radiators, heat vents, and other heat sources.
Because nearly half of all Christmas tree fires involve electrical malfunctions, it’s extremely important to check that light strands and other electrical decorations are in good condition (free from insulation cracks, fraying wires or damaged bulbs and plugs) before decorating your tree with them.